人人范文网 范文大全

中国印刷与包装学术会议英文格式要求

发布时间:2020-03-02 10:13:48 来源:范文大全 收藏本文 下载本文 手机版

Your Paper\'s Title Starts Here: Please Center

use Helvetica (Arial) 14

FULL First Author1, a, FULL Second Author2,b and Last Author3,c

2Full addre of first author, including country

3Full addre of second author, including country List all distinct addrees in the same way

aemail, bemail, cemail

Keywords: List the keywords covered in your paper.These keywords will also be used by the publisher to produce a keyword index.

For the rest of the paper, please use Times Roman (Times New Roman) 12

Abstract.This template explains and demonstrates how to prepare your camera-ready paper for Trans Tech Publications.The best is to read these instructions and follow the outline of this text.Please make the page settings of your word proceor to A4 format (21 x 29,7 cm or 8 x 11 inches); with the margins: bottom 1.5 cm (0.59 in) and top 2.5 cm (0.98 in), right/left margins must be 2 cm (0.78 in).

We shall be able to publish your paper in electronic form on our web page ,if the paper format and the margins are correct.

Your manuscript will be reduced by approximately 20% by the publisher.Please keep this in mind when designing your figures and tables etc.

Introduction

All manuscripts must be in English, also the table and figure texts, otherwise we cannot publish your paper.

Please keep a second copy of your manuscript in your office.When receiving the paper, we aume that the corresponding authors grant us the copyright to use the paper for the book or journal in question.Should authors use tables or figures from other Publications, they must ask the corresponding publishers to grant them the right to publish this material in their paper.

Use italic for emphasizing a word or phrase.Do not use boldface typing or capital letters except for section headings (cf.remarks on section headings, below).

Organization of the Text

Section Headings.The section headings are in boldface capital and lowercase letters.Second level headings are typed as part of the succeeding paragraph (like the subsection heading of this paragraph).Page Numbers.Do not number your paper:

Tables.Tables (refer with: Table 1, Table 2, ...) should be presented as part of the text, but in such a way as to avoid confusion with the text.A descriptive title should be placed above each table.Units in tables should be given in square brackets [meV].If square brackets are not available, use curly {meV} or standard brackets (meV).

Special Signs.for example , α γ μ Ω () ≥± ●Γ {1120} should always be written in with the fonts Times New Roman or Arial, especially also in the figures and tables.

Macros.Do not use any macros for the figures and tables.(We will not be able to convert such papers into our system)

Language.All text, figures and tables must be in English.

Figures.Figures (refer with: Fig.1, Fig.2, ...) also should be presented as part of the text, leaving enough space so that the caption will not be confused with the text.The caption should be self-contained and placed below or beside the figure.Generally, only original drawings or photographic reproductions are acceptable.Only very good photocopies are acceptable.Utmost care must be taken to insert the figures in correct alignment with the text.Half-tone pictures should be in the form of gloy prints.If poible, please include your figures as graphic images in the electronic version.For best quality the pictures should have a resolution of 300 dpi(dots per inch).

Color figures are welcome for the online version of the journal.Generally, these figures will be reduced to black and white for the print version.The author should indicate on the checklist if he wishes to have them printed in full color and make the neceary payments in advance.Equations.Equations (refer with: Eq.1, Eq.2, ...) should be indented 5 mm (0.2\").There should be one line of space above the equation and one line of space below it before the text continues.The equations have to be numbered sequentially, and the number put in parentheses at the right-hand edge of the text.Equations should be punctuated as if they were an ordinary part of the text.Punctuation appears after the equation but before the equation number, e.g.

c2 = a2 + b2.(1) Literature References

References are cited in the text just by square brackets [1].(If square brackets are not available, slashes may be used instead, e.g./2/.) Two or more references at a time may be put in one set of brackets [3,4].The references are to be numbered in the order in which they are cited in the text and are to be listed at the end of the contribution under a heading References, see our example below.Summary

If you follow the “checklist” your paper will conform to the requirements of the publisher and facilitate a problem-free publication proce.

References

[1] Dj.M.Maric, P.F.Meier and S.K.Estreicher: Mater.Sci.Forum Vol.83-87 (1992), p.119

[2] M.A.Green: High Efficiency Silicon Solar Cells (Trans Tech Publications, Switzerland 1987).

[3] Y.Mishing, in: Diffusion Procees in Advanced Technological Materials, edtied by D.Gupta

Noyes Publications/William Andrew Publising, Norwich, NY (2004), in pre.

[4] G.Henkelman, G.Johanneon and H.Jónon, in: Theoretical Methods in Condencsed Phase

Chemistry, edited by S.D.Schwartz, volume 5 of Progre in Theoretical Chemistry and Physics, chapter, 10, Kluwer Academic Publishers (2000).

[5] R.J.Ong, J.T.Dawley and P.G.Clem: submitted to Journal of Materials Research (2003)

[6] P.G.Clem, M.Rodriguez, J.A.Voigt and C.S.Ashley, U.S.Patent 6,231,666.(2001)

[7]Information on http://

附:中文说明 (仅是对上述英文的翻译,具体版式仍能照上述英文)

论文标题居中

(使用 Arial四号字体,加黑,间距:段前0,段后6磅,单倍行距)

第一作者全名,第二作者全名;第三作者

(Arial 四号字体,间距:段前6磅,段后0,单倍行距)

第一作者详细地址,包括国家

(Arial11磅字体,间距:段前6磅,段后0,单倍行距)

第二作者详细地址,包括国家

第三作者详细地址,包括国家

第一作者email, 第二作者email,第三作者email

关键词:列出您论文中的关键词。这些关键词将被出版商用于创建关键词索引

(使用 Arial11磅字体,间距:段前18磅,段后0,单倍行距, “ Keywords” 要加黑)。 论文其他部分请使用Times Roman (Times New Roman) (小四)字体

摘要:此模板说明并展示如何提供可出版的论文。请您阅读以下说明并遵照提示进行排版。 请将您的文字处理软件设置为A4版式(21 x 29,7厘米或8 x 11英寸),页边距为:底部1.5厘米(0.59英寸),顶部2.5厘米(0.98英寸),左/右边距为2厘米(0.78英寸),通栏排版。

引言

论文正文、图表和图形均需用英文撰写。

请自己保留一份原稿。当接收到论文的时候,即视为作者授予我们在特定的书籍和期刊中使用该论文的版权。如果作者使用了从别的出版物获取的表格和图形,则必须从该出版商处获得使用该材料的版权。

强调某个词或短语的时候使用斜体字。除了章节标题外(详见标题说明),不要使用黑体字或大写字母。

正文组织

章节标题:一级标题, 字体:Times Now Roman,加黑;字号:小四,间距:段前18磅,段后6磅,单倍行距,单词首字母大写,其余字母小写。二级标题紧随其后(像该段落的副标题),字体:Times Now Roman;字号:小四,间距:段前0磅,段后0磅,单倍行距,单词首字母大写,其余字母小写。三级标题,字体:Times Now Roman;字号:小四,间距:段前0磅,段后0磅,单倍行距,首行缩进0.5厘米,单词首字母大写,其余字母小写。

页码:不要标注论文页码。

表格:表格(标注为Table 1,Table 2,……)应以正文形式出现,但应避免与正文混淆。每个表格上面需有一个描述性的标题。表格中的单位需使用方括号[meV]。如果没有方括号,则使用大括号{meV}或标准括弧(meV)。

特殊符号:例如,α γ μ Ω () ≥± ●Γ {1120}应该为Times New Roman或Arial字体,在图形和表格中出现时也应为上述字体。

宏指令:不要在图形和表格中使用任何宏指令。(我们无法在我们的系统中进行转换)。

语言:正文、图形和图表必须为英文。

图形:图形(标注为Fig.

1、Fig.2……)应为正文的一部分,标题和正文之间留出一定的距离。标题应该独立,并被放置在图形的下方或旁边。一般情况下,只接受原始图和照片复制,如果是高质量的影印版,也可接受。将图形插入征文时需格外谨慎。网目调图像需要进行去网处理,为了达到最佳的效果,图形的像素应为300dpi。

一般情况下,所有图形将被转为黑白版本。作者应在作者清单中标注是否需要彩色印刷,并提前支付所需费用。

方程式:方程式(标注为Eq.1, Eq.2……)应缩进5毫米。方程式之上需空出一行,方程式之下需空出一行。方程式需依次排序,序号需标注在正文右侧的圆括号中。方程式需加标点符号,标点出现在方程式之后,序号之前。例如:

c2 = a2 + b2.(1)

参考文献:

参考文献以方括号[1]形式在论文中引用。(如果不能使用方括号,使用斜杠亦可,例如/2/,)两个或更多的文献可以放在一个方括号中,如[3,4]。文献资料需按正文中被引用的次序进行标序,并在论文的结尾部分“参考文献”的标题下列出,请参见下面的例子。

总结:

如果您遵照了上述说明,您的论文则符合出版商的要求,从而避免在出版过程中出现任何问题。

参考文献

* 期刊中的文章

[序号] 作者姓名: 期刊名称 卷数 (出版年份), p.页码.

例:[1] Dj.M.Maric, P.F.Meier and S.K.Estreicher: Mater.Sci.Forum Vol.83-87 (1992), p.119 (字体:Times Now Roman,小四号,间距:段前0磅,段后6磅,行距:最小值 14.4磅,悬挂缩进 0,74厘米)

* 图书

[序号] 作者姓名: 书名 (出版社, 出版地 出版年份)

例: [2] M.A.Green: High Efficiency Silicon Solar Cells (Trans Tech Publications, Switzerland

1987).

* 图书中的文章

[序号] 作者姓名, in: 书名, edtied by 编者姓名, 出版社, 出版地 (出版年份).

例:[3] Y.Mishing, in: Diffusion Procees in Advanced Technological Materials, edtied by D.Gupta

Noyes Publications/William Andrew Publising, Norwich, NY (2004), in pre.

* 丛书中的某图书中一章

[序号] 作者姓名, in: 书名, edtied by编者姓名, 丛书中的卷数, 引用的章节, 出版社 (出版年份).例: [4] G.Henkelman, G.Johanneon and H.Jónon, in: Theoretical Methods in Condencsed Phase

Chemistry, edited by S.D.Schwartz, volume 5 of Progre in Theoretical Chemistry and Physics, chapter, 10, Kluwer Academic Publishers (2000).

* 投到期刊未出版的文章

[序号] 作者姓名: submitted to 期刊名称(出版年份).

例: [5] R.J.Ong, J.T.Dawley and P.G.Clem: submitted to Journal of Materials Research (2003)

* 专刊

[序号] 申请者姓名, 国家 专利号.(发布年份)

例:[6] P.G.Clem, M.Rodriguez, J.A.Voigt and C.S.Ashley, U.S.Patent 6,231,666.(2001)

* 网络文章

[序号] information on 网址.

[7]Information on http://

上海印刷展(中国)上海印刷展印刷包装展

包装设计与印刷工艺

中国包装及包装印刷行业概况

印刷毕业论文 印刷包装行业与环保

英文学术会议邀请函

学术会议英文邀请函

包装印刷概论总结

3月印刷包装展会_3月印刷包装展会

包装印刷课程设计打印

印刷包装行业专业英语

中国印刷与包装学术会议英文格式要求
《中国印刷与包装学术会议英文格式要求.doc》
将本文的Word文档下载到电脑,方便编辑。
推荐度:
点击下载文档
点击下载本文文档